Why not just use a real GPS tracker?
Dedicated GPS trackers and Find My tags solve different problems. Here's the honest breakdown — cost, battery, coverage, and where each tool wins.
It's the first question most people ask when they hear AirTracker runs on Apple's Find My network. Fair question. Here's the honest breakdown.
The short answer
Dedicated GPS trackers and Find My tags solve different problems. If you need live, real-time tracking of a moving vehicle, a dedicated GPS unit is the right tool. If you need to know an asset is still where it should be, with an alert when it leaves, Find My tags plus the right software is faster to deploy, far cheaper and good enough for the vast majority of equipment and trailer hire businesses.
Cost
A dedicated GPS tracker typically runs $150 to $400 NZD per unit, plus an ongoing SIM data plan, plus installation costs if it's hardwired. For a fleet of 30 trailers, that's a serious upfront outlay before you've tracked anything.
Find My tags cost far less than that, and with AirTracker they come with the plan. We supply them preconfigured and posted ready to go; they are part of the plan and go back to us if you cancel. There's no SIM and no installation, and a tag clips or sticks onto the asset in under a minute. For the same fleet of 30, there's no hardware bill at all, and the tracking intelligence (geofencing, alerts, history) is handled in software.
The gap widens over time. Dedicated GPS trackers report location over the cellular network, which means a SIM data plan per unit, commonly $8 to $50 NZD a month depending on the provider and reporting frequency. Multiply that across a fleet and it stacks up fast, on top of the hardware. Find My tags run on Apple's Find My network, which carries no cellular fee at all. The only ongoing cost is your AirTracker subscription, priced per asset rather than per SIM — see the per-asset plans.
Battery life
This is the one people worry about most, and honestly, it's a strength, not a weakness.
A Find My tag runs on a battery, with no wiring and no charging schedule. Battery life depends on the tag and on how often it hears a passing Apple device, and it is set by the tag manufacturer. We don't repeat Apple's AirTag figure, because that is a number for a different device. Compare that to a hardwired GPS tracker, which needs to be wired into the vehicle's power system permanently, or a battery-powered GPS unit, which typically needs recharging every few days to a few weeks depending on the reporting frequency.
For equipment that isn't started and driven daily (trailers, bikes, generators, tools) a battery tag is a real operational advantage. There's no wiring, no vehicle power draw and no charging schedule to manage across a fleet.
It's also worth clarifying how AirTracker fits into this. Our dashboard checks Apple's Find My network about once a minute and shows the latest crowd-sourced report for each tag. A new report appears when an Apple device passes near the tag, so a busy road updates within minutes and a quiet paddock can take much longer. The tag's own battery drain is governed by its own broadcast behaviour, not by how often our software checks in on it.
Coverage and accuracy
Dedicated GPS trackers report their own location directly, on their own schedule, anywhere there's cellular signal. Find My tags rely on Apple's Find My network: nearby iPhones anonymously relaying the tag's location. That network is enormous. Apple describes it as a crowdsourced network of over a billion active Apple devices worldwide, which is exactly why it holds up so well anywhere there's regular foot and vehicle traffic. In a city or town centre, a tag can pass hundreds of iPhones an hour, any one of which can relay its location. In genuinely remote areas with little Apple device density, updates can be slower.
For most hire and rental businesses, where assets move around towns, depots, job sites and residential areas, Find My network density in NZ is more than sufficient. If your assets regularly go somewhere truly remote, that's a legitimate case for a dedicated tracker instead. If those assets are boats or jet skis, what boat tracking can and cannot do is the honest version.
Setup and scale
Fitting a dedicated GPS tracker usually means an installer, wiring and downtime per unit, and it needs to run off the vehicle's own power system, which rules out anything without an engine or electrical system: a trailer, a generator, a stack of tools, a bike. Find My tags have no such requirement. There's no wiring, no installer and no power source to tap into. A tag just clips, sticks or drops onto the asset in under a minute. That means it can go on genuinely anything that moves, trailers included.
Scaling follows the same pattern: growing a dedicated GPS fleet means booking an installer and downtime per vehicle, every time. Scaling Find My tags just means adding more tags to your plan. For a business testing whether tracking is even worth it, or growing from 10 assets to 100, that difference in friction adds up fast.
Where AirTracker fits in
Apple's own Find My app will show you where a tag is, but it stops there: no geofencing, no movement alerts, no history, no multi-user access for a team, no way to manage 50 assets at once. That's the gap AirTracker fills: geofencing, movement alerts, location history and a dashboard built for managing a fleet rather than a single tag under your own phone.
The bottom line
If you're tracking a small number of high-value moving vehicles that need constant live monitoring, a dedicated GPS system is still the right call. If you're managing a growing fleet of trailers, equipment or bikes and need to know they're where they should be, with an alert when something leaves its yard or site, Find My tags with the right software layer gets you there for a fraction of the cost and none of the install hassle.
If what you need is certified RUC and logbooks rather than asset location, a telematics system like EROAD is the right tool. If you only need to see trailers, plant and gear, how AirTracker compares is the shorter path.